FeelTech · Waveform generator
FeelTech FY6900-30M software
Remote control and data logging for the FeelTech FY6900-30M waveform generator, on Windows, Linux and macOS - with the same panel BenchMesh uses for every waveform generator.
Status
Very likely. Support for the FeelTech FY6900-30M was written from FeelTech’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real FY6900-30M yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
What you can do from BenchMesh
Waveform generator panel 1 channel
Live readings
- AMPL
- FREQ
- OFFS
- OUTPUT
- PHASE
- SHAPE
Settings you can change
- Amplitude
- Frequency
- Offset
- Output
- Phase
- Shape
Connections
- USB-serial / RS-232
- 115200 baud, 8N2. Plug in the USB cable (or a USB-RS-232 adapter); BenchMesh finds the port.
Notes
- Known issueThe frequency write unit (µHz or Hz) depends on the firmware version; CH2 not yet supported.
Sources
The definition was written from these documents (definition feeltech_fy6900 v0.1.0).
- FY6900 Serial communication protocol Rev 1.8, pages 2 (115200, LF, 0x0a ack), 6 (WMW indices), 8-9 (WMF/WMA/WMO/WMP/WMN), 10 (RMW), 12-13 (RMF/RMA/RMO/RMP/RMN), 35 (UMO)
- FY6900 User's Manual, pages 6 (model number = sine limit), 22 (offset ±12 V <20 MHz, ±2.5 V above), 37 (specifications)
Have one on your bench?
Connect it, press Detect, try the controls - then tell us how it went. Every confirmation moves a model from “Awaiting” to “Community-confirmed” for everyone.
Questions
- Does BenchMesh work with the FeelTech FY6900-30M?
- Very likely. Support for the FeelTech FY6900-30M was written from FeelTech’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real FY6900-30M yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
- How do I connect the FY6900-30M to my PC?
- Over USB-serial / RS-232. 115200 baud, 8N2. Plug in the USB cable (or a USB-RS-232 adapter); BenchMesh finds the port. Then press Detect in BenchMesh: it identifies the waveform generator by its reply and adds it to the bench.
- What can I control on the FY6900-30M?
- Waveform generator: set amplitude, frequency, offset, output, phase, shape; read ampl, freq, offs, output, phase, shape.
- Can I log FY6900-30M measurements to CSV?
- Yes. Right-click any reading to add it to a recording; every instrument on the bench is sampled on one shared timeline and exported as one CSV.
- Is BenchMesh free?
- Yes. BenchMesh is free and open source, for Windows, Linux and macOS, and works offline.