OWON · Waveform generator
OWON XDG2035 software
Remote control and data logging for the OWON XDG2035 waveform generator, on Windows, Linux and macOS - with the same panel BenchMesh uses for every waveform generator.
Status
Very likely. Support for the OWON XDG2035 was written from OWON’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real XDG2035 yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
What you can do from BenchMesh
Waveform generator panel 2 channels
Live readings
- AMPL
- FREQ
- LOAD
- OFFS
- OUTPUT
- PHASE
- SHAPE
- SYMM
Settings you can change
- Amplitude
- Frequency
- Offset
- Output
- Phase
- Shape
- Symmetry
Connections
- USB-TMC
- USB Test & Measurement Class (USB id 5345:1235). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click.
- LAN (SCPI socket)
- TCP port 3000. Enter the instrument’s IP address.
Notes
- Not supported (yet)Optional RS-232 on XDG2000: baud rate not documented.
Sources
The definition was written from these documents (definition owon_xdg v0.1.0).
- XDG Waveform Generator SCPI Protocol (2018), pages 10 (*IDN?), 12 (OUTPut:IMPedance), 13 (OUTPut:STATe), 30 (FREQuency), 39 (FUNCtion:SHAPe, RAMP:SYMMetry), 45 (PHASe), 60 (VOLTage, OFFSet)
- XDG2000 Series User Manual, pages 70-71 (frequency/amplitude specifications), 66 (USB/LAN)
- XDG Arbitrary Waveform Generator User Manual (XDG3000), pages 67-68 (specifications)
Have one on your bench?
Connect it, press Detect, try the controls - then tell us how it went. Every confirmation moves a model from “Awaiting” to “Community-confirmed” for everyone.
Questions
- Does BenchMesh work with the OWON XDG2035?
- Very likely. Support for the OWON XDG2035 was written from OWON’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real XDG2035 yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
- How do I connect the XDG2035 to my PC?
- Over USB-TMC or LAN (SCPI socket). USB Test & Measurement Class (USB id 5345:1235). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click. Then press Detect in BenchMesh: it identifies the waveform generator by its reply and adds it to the bench.
- What can I control on the XDG2035?
- Waveform generator: set amplitude, frequency, offset, output, phase, shape, symmetry; read ampl, freq, load, offs, output, phase, shape, symm.
- Can I log XDG2035 measurements to CSV?
- Yes. Right-click any reading to add it to a recording; every instrument on the bench is sampled on one shared timeline and exported as one CSV.
- Is BenchMesh free?
- Yes. BenchMesh is free and open source, for Windows, Linux and macOS, and works offline.