RIGOL · Waveform generator
RIGOL DG4062 software
Remote control and data logging for the RIGOL DG4062 waveform generator, on Windows, Linux and macOS - with the same panel BenchMesh uses for every waveform generator.
Status
Very likely. Support for the RIGOL DG4062 was written from RIGOL’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real DG4062 yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
What you can do from BenchMesh
Waveform generator panel 2 channels
Live readings
- AMPL
- FREQ
- LOAD
- OFFS
- OUTPUT
- PHASE
- SHAPE
- SYMM
Settings you can change
- Amplitude
- Frequency
- Offset
- Output
- Phase
- Shape
- Symmetry
Connections
- USB-TMC
- USB Test & Measurement Class (USB id 1ab1). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click.
- LAN (SCPI socket)
- TCP port 5555. Enter the instrument’s IP address.
Notes
- To confirm on first contactLAN port 5555 assumed (Rigol's usual port; not in the guide). USB product id conflicts between sources (0640 / 0641): vendor id only.
Sources
The definition was written from these documents (definition rigol_dg4000 v0.1.0).
- DG4000 Programming Guide PGB04108 (DG4000_ProgrammingGuide_EN.pdf), pages 148 (*IDN?), 199-201 (OUTPut STATe/IMPedance), 319-324 (FREQ), 337-341 (FUNC, RAMP:SYMM), 477-478 (PHAS), 517-527 (VOLT, OFFS, UNIT); USB id p557 (VISA example USB0::0X1AB1::0X0640)
Have one on your bench?
Connect it, press Detect, try the controls - then tell us how it went. Every confirmation moves a model from “Awaiting” to “Community-confirmed” for everyone.
Questions
- Does BenchMesh work with the RIGOL DG4062?
- Very likely. Support for the RIGOL DG4062 was written from RIGOL’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real DG4062 yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
- How do I connect the DG4062 to my PC?
- Over USB-TMC or LAN (SCPI socket). USB Test & Measurement Class (USB id 1ab1). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click. Then press Detect in BenchMesh: it identifies the waveform generator by its reply and adds it to the bench.
- What can I control on the DG4062?
- Waveform generator: set amplitude, frequency, offset, output, phase, shape, symmetry; read ampl, freq, load, offs, output, phase, shape, symm.
- Can I log DG4062 measurements to CSV?
- Yes. Right-click any reading to add it to a recording; every instrument on the bench is sampled on one shared timeline and exported as one CSV.
- Is BenchMesh free?
- Yes. BenchMesh is free and open source, for Windows, Linux and macOS, and works offline.