RIGOL · Oscilloscope
RIGOL DHO1072 software
Remote control and data logging for the RIGOL DHO1072 oscilloscope, on Windows, Linux and macOS - with the same panel BenchMesh uses for every oscilloscope.
Awaiting confirmation
Status
Very likely. Support for the RIGOL DHO1072 was written from RIGOL’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real DHO1072 yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
What you can do from BenchMesh
Oscilloscope panel 2 channels
Live readings
- ACQ TYPE
- BWLIMIT
- COUPLING
- DISPLAY
- FREQ
- INVERT
- OFFSET
- PROBE
- SCALE
- SRATE
- TIMEBASE
- TIMEOFFSET
- TRIG LEVEL
- TRIG SLOPE
- TRIG SOURCE
- TRIG STATUS
- TRIG SWEEP
- VAVG
- VPP
- VRMS
Settings you can change
- Acquire type
- Bwlimit
- Coupling
- Display
- Invert
- Offset
- Probe
- Run
- Scale
- Timebase
- Timebase offset
- Trigger level
- Trigger slope
- Trigger source
- Trigger sweep
Connections
- USB-TMC
- USB Test & Measurement Class (USB id 1ab1). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click.
- LAN (SCPI socket)
- TCP port 5555. Enter the instrument’s IP address.
Notes
- To confirm on first contactUSB product id not documented: vendor id only.
Sources
The definition was written from these documents (definition rigol_dho1000 v0.1.0).
- DHO1000/DHO4000 Programming Guide PGA34101-1110 (DHO1000-4000_ProgrammingGuide_EN.pdf), pages PDF p24 models, p28-31 RUN/STOP/SINGle/CLEar/AUToset, p41 ACQuire:TYPE/SRATe, p94-102 CHANnel, p144 *IDN?, p196-197 MEASure:ITEM, p292-293 TIMebase, p301-307 TRIGger, p433-441 WAVeform
Have one on your bench?
Connect it, press Detect, try the controls - then tell us how it went. Every confirmation moves a model from “Awaiting” to “Community-confirmed” for everyone.
Questions
- Does BenchMesh work with the RIGOL DHO1072?
- Very likely. Support for the RIGOL DHO1072 was written from RIGOL’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real DHO1072 yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
- How do I connect the DHO1072 to my PC?
- Over USB-TMC or LAN (SCPI socket). USB Test & Measurement Class (USB id 1ab1). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click. Then press Detect in BenchMesh: it identifies the oscilloscope by its reply and adds it to the bench.
- What can I control on the DHO1072?
- Oscilloscope: set acquire type, bwlimit, coupling, display, invert, offset, probe, run; read acq type, bwlimit, coupling, display, freq, invert, offset, probe.
- Can I log DHO1072 measurements to CSV?
- Yes. Right-click any reading to add it to a recording; every instrument on the bench is sampled on one shared timeline and exported as one CSV.
- Is BenchMesh free?
- Yes. BenchMesh is free and open source, for Windows, Linux and macOS, and works offline.