Siglent · Electronic load
Siglent SDL1020X-E software
Remote control and data logging for the Siglent SDL1020X-E electronic load, on Windows, Linux and macOS - with the same panel BenchMesh uses for every electronic load.
Status
Very likely. Support for the Siglent SDL1020X-E was written from Siglent’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real SDL1020X-E yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
What you can do from BenchMesh
Electronic load panel 1 channel
Live readings
- IIN
- INPUT
- MODE
- PIN
- VIN
Settings you can change
- Curr
- Input
- Mode
- Pow
- Remote compensation
- Res
- Short
- Volt
Connections
- USB-TMC
- USB Test & Measurement Class (USB id f4ec). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click.
- LAN (SCPI socket)
- TCP port 5025. Enter the instrument’s IP address.
Notes
- To confirm on first contactUSB product id not documented (vendor f4ec only).
Sources
The definition was written from these documents (definition siglent_sdl1000x v0.1.0).
- SDL1000X Programming Guide E02B (SDL1000X_programming_guide_E02B.pdf), pages 7, 14, 15, 17-20, 24, 27, 30-31, 53-54
Have one on your bench?
Connect it, press Detect, try the controls - then tell us how it went. Every confirmation moves a model from “Awaiting” to “Community-confirmed” for everyone.
Questions
- Does BenchMesh work with the Siglent SDL1020X-E?
- Very likely. Support for the Siglent SDL1020X-E was written from Siglent’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real SDL1020X-E yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
- How do I connect the SDL1020X-E to my PC?
- Over USB-TMC or LAN (SCPI socket). USB Test & Measurement Class (USB id f4ec). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click. Then press Detect in BenchMesh: it identifies the electronic load by its reply and adds it to the bench.
- What can I control on the SDL1020X-E?
- Electronic load: set curr, input, mode, pow, remote compensation, res, short, volt; read iin, input, mode, pin, vin.
- Can I log SDL1020X-E measurements to CSV?
- Yes. Right-click any reading to add it to a recording; every instrument on the bench is sampled on one shared timeline and exported as one CSV.
- Is BenchMesh free?
- Yes. BenchMesh is free and open source, for Windows, Linux and macOS, and works offline.