Siglent · Oscilloscope
Siglent SDS824X HD software
Remote control and data logging for the Siglent SDS824X HD oscilloscope, on Windows, Linux and macOS - with the same panel BenchMesh uses for every oscilloscope.
Status
Very likely. Support for the Siglent SDS824X HD was written from Siglent’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real SDS824X HD yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
What you can do from BenchMesh
Oscilloscope panel 4 channels
Live readings
- ACQ TYPE
- BWLIMIT
- COUPLING
- DISPLAY
- FREQ
- INVERT
- OFFSET
- PROBE
- SCALE
- SRATE
- TIMEBASE
- TIMEOFFSET
- TRIG LEVEL
- TRIG SLOPE
- TRIG SOURCE
- TRIG STATUS
- TRIG SWEEP
- VAVG
- VPP
- VRMS
Settings you can change
- Acquire type
- Bwlimit
- Coupling
- Display
- Invert
- Offset
- Probe
- Run
- Scale
- Timebase
- Timebase offset
- Trigger level
- Trigger slope
- Trigger source
- Trigger sweep
Connections
- USB-TMC
- USB Test & Measurement Class (USB id f4ec). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click.
- LAN (SCPI socket)
- TCP port 5025. Enter the instrument’s IP address.
Sources
The definition was written from these documents (definition siglent_sds800xhd v0.1.0).
- SDS Series Programming Guide EN11G (SDS800XHD_Series_ProgrammingGuide.pdf), pages PDF p19 supported models (SDS800X HD from firmware 1.1.3.1), p25 LAN 5025, p31 *IDN?, p34 AUToset, p42-48 ACQuire, p51-61 CHANnel, p337-369 MEASure, p474-496 TIMebase/TRIGger, p748-760 WAVeform
Have one on your bench?
Connect it, press Detect, try the controls - then tell us how it went. Every confirmation moves a model from “Awaiting” to “Community-confirmed” for everyone.
Questions
- Does BenchMesh work with the Siglent SDS824X HD?
- Very likely. Support for the Siglent SDS824X HD was written from Siglent’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real SDS824X HD yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
- How do I connect the SDS824X HD to my PC?
- Over USB-TMC or LAN (SCPI socket). USB Test & Measurement Class (USB id f4ec). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click. Then press Detect in BenchMesh: it identifies the oscilloscope by its reply and adds it to the bench.
- What can I control on the SDS824X HD?
- Oscilloscope: set acquire type, bwlimit, coupling, display, invert, offset, probe, run; read acq type, bwlimit, coupling, display, freq, invert, offset, probe.
- Can I log SDS824X HD measurements to CSV?
- Yes. Right-click any reading to add it to a recording; every instrument on the bench is sampled on one shared timeline and exported as one CSV.
- Is BenchMesh free?
- Yes. BenchMesh is free and open source, for Windows, Linux and macOS, and works offline.