Skip to content
BenchMesh
Download

Aim-TTi · Power supply

Aim-TTi MX100TP software

Remote control and data logging for the Aim-TTi MX100TP power supply, on Windows, Linux and macOS - with the same panel BenchMesh uses for every power supply.

Awaiting confirmation

Status

Very likely. Support for the Aim-TTi MX100TP was written from Aim-TTi’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real MX100TP yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.

Note: Output 1: 16V/6A or 35V/3A; output 2: 35V/3A, 16V/6A or 35V/6A (disables output 3); output 3: 35V/3A, 70V/1.5A or 70V/3A (p.13, p.36). Setpoints outside the selected range are rejected (EER 100).

What you can do from BenchMesh

Power supply panel 3 channels

Live readings

  • IOUT
  • OUTPUT
  • POUT
  • REMOTE
  • SBY
  • VOUT

Settings you can change

  • Current
  • Current limit
  • Ocp
  • Output
  • Ovp
  • Voltage
  • Voltage limit

Connections

USB-serial / RS-232
9600 baud, 8N1. Plug in the USB cable (or a USB-RS-232 adapter); BenchMesh finds the port.
LAN (SCPI socket)
TCP port 9221. Enter the instrument’s IP address.

Notes

  • Not supported (yet)GPIB (option) not supported.

Sources

The definition was written from these documents (definition tti_mx v0.1.0).

  • MX100T & MX100TP Instruction Manual 48511-1610 Iss. 9, pages 4, 12-13 (OVP/OCP, ranges), 25-29 (interfaces, LSR), 34-39 (commands), 41-44 (specs)

Have one on your bench?

Connect it, press Detect, try the controls - then tell us how it went. Every confirmation moves a model from “Awaiting” to “Community-confirmed” for everyone.

Download BenchMeshHow to confirm an instrument

Questions

Does BenchMesh work with the Aim-TTi MX100TP?
Very likely. Support for the Aim-TTi MX100TP was written from Aim-TTi’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real MX100TP yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
How do I connect the MX100TP to my PC?
Over USB-serial / RS-232 or LAN (SCPI socket). 9600 baud, 8N1. Plug in the USB cable (or a USB-RS-232 adapter); BenchMesh finds the port. Then press Detect in BenchMesh: it identifies the power supply by its reply and adds it to the bench.
What can I control on the MX100TP?
Power supply: set current, current limit, ocp, output, ovp, voltage, voltage limit; read iout, output, pout, remote, sby, vout.
Can I log MX100TP measurements to CSV?
Yes. Right-click any reading to add it to a recording; every instrument on the bench is sampled on one shared timeline and exported as one CSV.
Is BenchMesh free?
Yes. BenchMesh is free and open source, for Windows, Linux and macOS, and works offline.