UNI-T · Multimeter
UNI-T UT8805E software
Remote control and data logging for the UNI-T UT8805E multimeter, on Windows, Linux and macOS - with the same panel BenchMesh uses for every multimeter.
Awaiting confirmation
Status
Very likely. Support for the UNI-T UT8805E was written from UNI-T’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real UT8805E yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
What you can do from BenchMesh
Multimeter panel 1 channel
Live readings
- MEAS
- MODE
- OVERLOAD
- RANGE
Settings you can change
- Mode
- Range
- Rate
- Temp scale
Connections
- USB-serial / RS-232
- 9600 baud, 8N1. Plug in the USB cable (or a USB-RS-232 adapter); BenchMesh finds the port.
- USB-TMC
- USB Test & Measurement Class. No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click.
- LAN (VXI-11 / LXI)
- Discovered through the portmapper, no port to enter. Enter the instrument’s IP address.
Notes
- To confirm on first contactLAN works through VXI-11 (no raw socket): supported, not yet confirmed on hardware.
Sources
The definition was written from these documents (definition unit_ut8805e v0.1.0).
- UT8805E SCPI Programming Manual (unitrend), pages 9-14 CONFigure, 28-44 SENSe (printed x/49)
- UT8805E User Manual, pages 14 speed, RS-232C setting (Uart menu)
- UT8806E SCPI Programming Manual, pages 6 *IDN?, 26 FUNC? (same vendor dialect)
Have one on your bench?
Connect it, press Detect, try the controls - then tell us how it went. Every confirmation moves a model from “Awaiting” to “Community-confirmed” for everyone.
Questions
- Does BenchMesh work with the UNI-T UT8805E?
- Very likely. Support for the UNI-T UT8805E was written from UNI-T’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real UT8805E yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
- How do I connect the UT8805E to my PC?
- Over USB-serial / RS-232 or USB-TMC or LAN (VXI-11 / LXI). 9600 baud, 8N1. Plug in the USB cable (or a USB-RS-232 adapter); BenchMesh finds the port. Then press Detect in BenchMesh: it identifies the multimeter by its reply and adds it to the bench.
- What can I control on the UT8805E?
- Multimeter: set mode, range, rate, temp scale; read meas, mode, overload, range.
- Can I log UT8805E measurements to CSV?
- Yes. Right-click any reading to add it to a recording; every instrument on the bench is sampled on one shared timeline and exported as one CSV.
- Is BenchMesh free?
- Yes. BenchMesh is free and open source, for Windows, Linux and macOS, and works offline.