Siglent · Multimeter
Siglent SDM3055 software
Remote control and data logging for the Siglent SDM3055 multimeter, on Windows, Linux and macOS - with the same panel BenchMesh uses for every multimeter.
Status
Very likely. Support for the Siglent SDM3055 was written from Siglent’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real SDM3055 yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
Note: Also SDM3055X-E / SDM3055-SC
What you can do from BenchMesh
Multimeter panel 1 channel
Live readings
- MEAS
- MODE
- OVERLOAD
- RANGE
Settings you can change
- Mode
- Range
- Rate
- Temp scale
- Temp sensor
Connections
- USB-TMC
- USB Test & Measurement Class (USB id f4ec:ee38). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click.
- LAN (SCPI socket)
- TCP port 5025. Enter the instrument’s IP address.
Notes
- To confirm on first contactLAN port 5025 confirmed on hardware by a user; Siglent's app note says 5024.
Sources
The definition was written from these documents (definition siglent_sdm3000 v0.1.0).
- SDM3065X Remote Manual RC06036-E01A, pages 37-48, 54-61, 77-84 (printed)
- SDM3055 Remote Manual RC06035-E01A, pages 36-47, 60, 83 (printed)
- SDM3045X Programming Manual, pages 37-48, 61, 83 (printed)
Have one on your bench?
Connect it, press Detect, try the controls - then tell us how it went. Every confirmation moves a model from “Awaiting” to “Community-confirmed” for everyone.
Questions
- Does BenchMesh work with the Siglent SDM3055?
- Very likely. Support for the Siglent SDM3055 was written from Siglent’s programming manual and follows the same engine as the bench-tested instruments, but nobody has confirmed it on a real SDM3055 yet. If you own one, connecting it once and reporting the result moves it to Community-confirmed.
- How do I connect the SDM3055 to my PC?
- Over USB-TMC or LAN (SCPI socket). USB Test & Measurement Class (USB id f4ec:ee38). No vendor driver needed on Linux; on Windows BenchMesh installs Microsoft’s WinUSB driver with one click. Then press Detect in BenchMesh: it identifies the multimeter by its reply and adds it to the bench.
- What can I control on the SDM3055?
- Multimeter: set mode, range, rate, temp scale, temp sensor; read meas, mode, overload, range.
- Can I log SDM3055 measurements to CSV?
- Yes. Right-click any reading to add it to a recording; every instrument on the bench is sampled on one shared timeline and exported as one CSV.
- Is BenchMesh free?
- Yes. BenchMesh is free and open source, for Windows, Linux and macOS, and works offline.